Instructions – Crystal Bro

CLICK HERE TO WATCH THE INSTRUCTIONAL VIDEO!!

Important to understand

Crystal Bro is not a ceramic paint protection and not a polish.

It is a self-leveling treatment as:

Fills scratches and swirl marks optically
Gives deeper colour and high gloss
Protective film over the paintwork/clear coat

After full curing, this is the film that takes the wear and protects the car’s original surface.

Do not use on

Foliering / PPF
Existing protection (wax, ceramic coating, etc.)
Glass
Carbon fiber
Invändiga ytor

Step 1 – Preparation (Most Important)

The surface must be:

Completely pure
Completely dry
Free from wax, oils and residue

Wash the car thoroughly and remove any previous protection.

Poor preparation is the most common cause of poorer results.

Step 2 – The right conditions

Work in 15–24°C
Avoid cold and excessive heat
Work on a cool surface

Always start with a smaller area (e.g. a door).
Take the bonnet last once you've got the hang of it.

Step 3 – Prepare the applicator

Fully saturate the applicator
It should be completely soaked through – not dry anywhere
Fill up the product after 2–4 swipes

Step 4 – Application

Apply a generous and even layer
Work with straight strokes (not back and forth)
Use a even, controlled pressure

⚠️ Important:

Go over the surface only once
If more than ~5 seconds have passed → do not go back
Don't overwork the surface

Crystal Bro should not polished in.
It is self-leveling and should be left after application.

Step 5 – Check

Do you see stripes?

Most often too little product or uneven application

Solution:

Let the surface cure
Apply a new coat as needed

Do not rub during curing.

Step 6 – Curing (48 hours)

For at least 48 hours (may require more in colder environments):

Keep the car completely dry
Avoid rain, moisture, and snow
Touching the surface during the first few days

Moisture during curing can cause white or cloudy marks.

Results

After full curing, you get:

Deep colour
Increased shine
Minor visible scratches and swirl marks

On heavily worn lacquer, a second application may be necessary.

Important to understand

Crystal Bridge:

Restores and improves appearance
Visually fills scratches

Your:

Repairs not deep scratches
Works not on damaged paintwork

How to remove Crystal Bro

Do you want to remove the product:

Spray the entire surface with IPA (isopropanol), then wipe with a cloth
Polish off the film that has formed over the paint/clear coat. During the first few days, a light polish is enough, but if the product has set properly, a coarser polish may be required to remove the film!

Aftercare

Don't wash the car on 14 days
Avoid chemicals during this period

Important:

Avoid wiping off the finish or trying to remove the product before they 14 days has gone.
Depending on the environment, the product may need time to set properly.

Kerosene degreaser:

Used with caution
Max 5–6 minutes per wash

Common mistakes

❌ Too little product → streaks
❌ Too much pressure → uneven results and streaks
❌ Application in cold conditions → poor leveling and rainbow streaks
❌ Application in heat → the product sets too quickly and causes streaks
❌ Poor prep work → reduced durability
Moisture during curing → white marks